9:41
Forklift daily inspection
FL-02 · Toyota 8FBEK16 · Dana Whitfield
Step 3 of 8 · same steps every shift ~4 min
3Forks and heel wear
Compare both heels against the reference. Replace if wear exceeds 10% of thickness.
Fail
Pass
Remaining steps
Hour meter reading
Hydraulic oil level
Horn and reverse alarm
How this step is done
Hydraulics · written by Ryan Keller · 4 years on this fleet
1Lower the mast fully and set the park brake
2Measure heel thickness at both forks with the gauge
3Compare against 45 mm original — replace below 40.5 mm
Fail this step if either fork reads under 40.5 mm
1
2
3
4
5
6
7
8
9
.
0
Save
Step failed — raise a work order?
Hydraulic oil level · FL-02 · the failed step and its photo travel with it.
Add a note
Raise work order
WO-8963 raised from step 5Assigned to Ryan Keller · inspection continues